Type Alias: SetDynamicConfigParams

SetDynamicConfigParams = { feeAdmin: string; poolAddress: string; rateLimitAdmin: string; router: string; sender?: string; }

Defined in: cct/evm/token-pool/operations/set-dynamic-config.ts:47

Parameters for SetDynamicConfig. The three config fields keep the contract struct's names — router/rateLimitAdmin/feeAdmin, with no new prefix — because this op replaces the whole struct rather than assigning one role, and every field is required: omitting one would mean reading the current value at build time, which is exactly what this op refuses to do (see the module remarks).

Properties

feeAdmin

feeAdmin: string

Defined in: cct/evm/token-pool/operations/set-dynamic-config.ts:69

Address allowed to change the pool's token-transfer fee config alongside the owner. Zero is allowed, on the same reasoning as SetDynamicConfigParams.rateLimitAdmin.

---

poolAddress

poolAddress: string

Defined in: cct/evm/token-pool/operations/set-dynamic-config.ts:50

Token pool to reconfigure. Must be non-zero — it is the tx to, and a call to 0x0 hits no code, so it would mine as a successful no-op.

---

rateLimitAdmin

rateLimitAdmin: string

Defined in: cct/evm/token-pool/operations/set-dynamic-config.ts:64

Address allowed to change the pool's rate limits alongside the owner. The zero address is allowed and meaningful: it clears the delegation, leaving the owner as the only account that can change rate limits. Revoking a delegated admin is legitimate — and on incident response, urgent — so it is not rejected here.

---

router

router: string

Defined in: cct/evm/token-pool/operations/set-dynamic-config.ts:57

Router the pool accepts lockOrBurn/releaseOrMint calls from. Must be non-zero: unlike the two admin roles this is not a delegable privilege but the pool's only bridging counterparty, so a zero value does not "clear" anything — it detaches the pool from CCIP entirely and every transfer through it reverts until an owner tx restores it.

---

sender?

optional sender?: string

Defined in: cct/evm/token-pool/operations/set-dynamic-config.ts:77

The pool owner. Sets tx.from for offline / multisig signing, and when supplied is checked against the pool's on-chain owner() before any calldata is built. Optional for SetDynamicConfig.generate (an offline builder may not yet know the signer); SetDynamicConfig.execute defaults it to the signing wallet, so the owner check always runs on a broadcast tx.